Using This Feature; Controlling The Ipod Or External Usb Device Using Radio Buttons - Jeep Grand Cherokee 2012 Owner's Manual

Hide thumbs Also See for Grand Cherokee 2012:
Table of Contents

Advertisement

without damaging it while closing the lid. If a cut out is
not available in the center console base, route the cable
away from the lid latch and in a place that will allow the
lid to close without damaging the cable.
Once the audio device is connected and synchronized to
the vehicle's iPod /USB/MP3 control system (iPod or
external USB device may take a few minutes to connect),
the audio device starts charging and is ready for use by
pressing radio switches, as described below.
NOTE: If the audio device battery is completely dis-
charged, it may not communicate with the iPod /USB/
MP3 control system until a minimum charge is attained.
Leaving the audio device connected to the iPod /USB/
MP3 control system may charge it to the required level.
UNDERSTANDING YOUR INSTRUMENT PANEL 353

Using This Feature

By using iPod cable or external USB device to connect to
USB port:
• The audio device can be played on the vehicle's sound
system, providing metadata (artist, track title, album,
etc.) information on the radio display.
• The audio device can be controlled using the radio
buttons to Play, Browse, and List the iPod contents.
• The audio device battery charges when plugged into
the USB/AUX connector (if supported by the specific
audio device)
Controlling The iPod Or External USB Device
Using Radio Buttons
To get into the iPod /USB/MP3 control mode and access
a connected audio device, either press the "AUX" button
on the radio faceplate or press the VR button and say
USB or Switch to USB . Once in the iPod /USB/MP3
4

Advertisement

Table of Contents
loading

Table of Contents