Jeep Grand Cherokee 2012 Owner's Manual page 327

been deactivated. When this feature is deactivated, the
system reverts to the standard intermittent wiper
operation.
Hill Start Assist (HSA)
When this feature is selected, the HSA system is active.
Refer to "Electronic Brake Control System" in "Starting
And Operating" for system function and operating infor-
mation. To make your selection, press and release the
SELECT button until a check-mark appears next to the
feature showing the system has been activated or the
check-mark is removed showing the system has been
deactivated.
Blind Spot Alert
There are three selections when operating Blind Spot
Alert. By pressing and releasing the SELECT button once,
the Blind Spot Alert feature can be activated in "Blind
Spot: Lights Only" mode. When this mode is selected the
Blind Spot Monitor (BSM) system is activated and will
UNDERSTANDING YOUR INSTRUMENT PANEL 325
only show a visual alert in the outside mirrors. By
pressing and releasing the SELECT button a second time
"Blind Spot: Lights/CHM" mode is activated. In this
mode the Blind Spot Monitor (BSM) will show a visual
alert in the outside mirrors as well as an audible alert
when the turn signal is on. When "Blind Spot: Off" is
selected the Blind Spot Monitor (BSM) system is deacti-
vated.
NOTE: If your vehicle has experienced any damage in
the area where the sensor is located, even if the fascia is
not damaged, the sensor may have become misaligned.
Take your vehicle to an authorized dealer to verify sensor
alignment. Having a sensor that is misaligned will result
in the BSM not operating to specification.
Forward Collision Warning
The Forward Collision Warning (FCW) feature can be can
be set to Far, set to Near or turned Off. The default status
of FCW is the Far setting. This means the system will
4