Advertisement
18
Connect white wire from fan to white
wire from light fixture, then connect
blue wire from fan to black wire from
light fixture.
20
A t t a c h b l a n k i n g p l a t e b y l o c a t i n g
dimples in light fixture with grooves in
the blanking plate and twist clockwise to
WARNING:Make sure
lock in place.
light bulb is not installed when using
this cover.
23
Remove battery cover. Install 12V battery
into wall remote. Duracell MN21 / Eveready
A23 / GP 23A all 12V.Attach cover of remote
by placing over buttons and snap the battery
cover in place.
26
Attach front cover to wall control
with screws provided. Snap battery
cover in place.
19
Align keyslot holes of the light fixture
with the screws on light pan and twist
clockwise till tight. Install the screw
which removed in step 17. Tighten all
screws securely.
21
Install 100-watt G9 base bulbs. Bulbs
included. WARNING: Over lamping the
fan will result in the fan lights shutting
down until the proper wattage of bulbs
are installed.Reset the lights by turning
off, replace bulbs with the correct
wattage bulbs, turn the power on.
Note: Do not replace bulb until it cools
down.
24
HAND HELD INSTALL
Place face plate over battery compartment
and buttons. Place remote over 2 pins on front
cover. Attach cover of remote by placing over
4 pins and snapping into place.
For fan without light, go
to step 20
For fan with light, go to
step 21
22
Attach the glass by locating dimples
in light fixture with groves in the
glass and twist clockwise until tight.
25
WALL MOUNT INSTALL
Install wall control unit to outlet box
using machine screws provided.
Advertisement
