Advertisement
7
Remote transmitter dip switch
Remote receiver dip switch
Set dip switches on the Remote Transmitter
and Remote Receiver to the same settings.
T h i s m u s t b e d o n e s o t h e u n i t s w i l l
communcate properly. If you have other fans
you can set to control from one transmitter
by setting both receivers the same as the
transmitter. If you have more than one fan
with remote. You can set the dip switches to
different positiosns to have seperate control.
10
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the wire
connections, the wires should be spread apart
with the grounded conductor and the equipment-
grounding conductor on one side of the outlet
box and ungrounded conductor on the other side
of the outlet box. The splices after being made
should be turned upward and pushed carefully up
into the outlet box.
13
Coupling
Flywheel
Attach flywheel onto coupling on motor
assembly, aligning any of the 6 holes
on flywheel with the thread hole on the
coupling with arrow. Install 6 screws
provided to secure the flywheel. Tighten
all screws securely.
15
L o o s e n t w o a n d r e m o v e o n e
preassembled screw from the plate
on motor assembly. Keep screw for
later use.
8
Carefully lift the fan motor assembly
and engage the slot in the motor
h o u s i n g w i t h t h e h o o k o n t h e
mounting plate so that the motor is
securely suspended.
11
Lift the motor assembly up, aligning the
holes on the plate of motor assembly
with the screws on mounting plate.
Re-install the hex nut and washers
removed in step 3 to secure motor
assembly. Tighten all hex nuts securely.
14
Insert blade into the slot on flywheel and install blade screws, fiber washers
and enhance plate aligning each of the holes as shown. Repeat this process
for remaining blades.
Note: Make sure the side with a label "This side up" is installed upward.
Note: Make sure the holes on blade align with the alignment post on motor
assembly.
16
Attach light pan onto the plate on
motor assembly, aligning its keyhole
slots with the screws on plate and
twist clockwise till lock. Re-install
the screw removed in step 15.
Tighten all screw securely.
9
Receiver
Make wiring connections as indicated above.
White (Neutral) from house to white from remote
receiver marked AC N . Black (Live) from house to
Black from remote receiver marked AC L. Connect
all green ground wires to Grounded wire from
House.
12
Lift decorative housing to mounting
palet. Twist slots on decorative
housing into pins on mounting plate
clockwise to secure.
Alignment post
17
Loosen two screws and remove one
screw from light pan. Save screw
for later use.
Supply
circuit
Slot
Pin
Enhance plate
Advertisement
