Using The Controls - Image IMSB53950 User Manual

Using the Controls

Blower
Mode
Button
Button
Pump
Pump
Button 1 Button 2
1
2
1
3
1
4
Air control 1 determines the amount of air flowing
through the hydrotherapy jets labeled 1 in the drawing
above. If the control is turned counterclockwise, the
amount of air will increase; if the control is turned
clockwise, the amount of air will decrease. Air controls
2, 3, and 4 function in the same manner.
Air controls 2, 3, and 4 determine the amount of air
flowing through the hydrotherapy jets labeled 2, 3,
and 4 in the drawing above.
The Mode button switches the console between
Standard, Economy, and Sleep modes.
• Standard Mode maintains the set temperature. Note:
The actual temperature displayed will equal the set
temperature only when pump 1 has been operating
for two minutes. "Std" displays momentarily when
Air Controls
1, 2, and 3
Display
Light Temperature
Button Buttons
2
1 5
5
3
5
4
5
5
3
4
standard mode is selected.
• Economy Mode heats the spa to the set tempera-
ture only during the filter cycles. "Ecn" is always dis-
played when the actual temperature does not equal
the set temperature. "Ecn" alternates with the actual
temperature when the actual temperature is the set
temperature.
• Sleep Mode heats the spa to within 20°F of the set
temperature during the filter cycles only. "Slp" is
always displayed when the actual temperature does
not equal the set temperature. "Slp" alternates with
the actual temperature when the actual temperature
is the set temperature.
Pump button 1 controls the spa jets labeled 3 and 4
in the drawing at the left. If the button is pressed
once, the jets will run at low speed. If the button is
pressed again, the jets will run at high speed. If the
button is pressed a third time, the jets will shut off.
Pump button 2 controls the spa jets labeled 1 and 2
in the drawing at the left. If the button is pressed
once, the jets will run, providing soothing hydrothera-
py. If the button is pressed again, the jets will shut off.
The spa also features an automatic mode that heats
and filters the water when the spa is left unattended.
When the power to the spa is first turned on, or if the
water temperature is below the set temperature, the
water will be heated as required. Note: To keep the
filter and heat cycles from running, the power to
the spa must be turned off.
14
Air Control 4