Using The Controls - Image Renew 716 User Manual

Using the Controls

Air Controls
1 and 2
Temperature
Jet
Button
Button
1
2
1
Air Control 1: Determines the amount of air flowing
through the hydrotherapy jets labeled 1 above. If the
control is turned counterclockwise, the amount of air
will increase; if the control is turned clockwise, the
amount of air will decrease. Air control 2 functions in
the same manner.
Air Control 2: Determines the amount of air flowing
through the hydrotherapy jets labeled 2 above.
Jet Button: Turns the spa jets on and off. This is a
two-speed button. If the button is pressed once, the
spa jets will run at low speed, providing gentle
Display
Temperature
Light
Button
Button
2
hydrotherapy. If the button is pressed twice, the spa
jets will run at high speed, providing moderate-pres-
sure hydrotherapy. If the button is pressed again, the
jets will shut off.
The spa also features an automatic mode that heats
and filters the water when the spa is left unattended.
When the power to the spa is first turned on, or if the
water temperature is below the set temperature, the
water will be heated as required to maintain the set
temperature. Note: To keep the filter and heat
cycles from running, the power to the spa must be
turned off.
Light Button: Turns the underwater light on and off.
Temperature Buttons: Control the temperature setting
of the water. The temperature can be set between
80°F and 104°F. The water heats at about 6°F per
hour with the cover on. Use a medical or other accu-
rate thermometer to check the temperature of the
water. Note: The word "COOL" will appear in the con-
sole display if the temperature of the water is more
than 20°F cooler than the set temperature. When this
happens, the heater will automatically activate to warm
the water. The word "ICE" will appear in the display if
the temperature drops below 40°F. If this happens, the
pump will automatically circulate the water and warm
the plumbing to keep the water from freezing.
12