Image IMSB53950 User Manual page 10

3. Make sure that a qualified electrician has wired
the spa to a 240 volt power source.
Remove the two warning decals (see page 5) from
the spa shell. Using a damp cloth, wipe the spa shell
clean. Before filling the spa, make sure that it is
in the desired position and that there is room to
easily service it. Once the spa is filled, it must be
drained before it can be moved.
Insert a garden hose into the filter housing, and
begin filling the spa. Do not use soft water. The
spa may be filled with cold water; however, if warm
or hot water is used, the spa will be ready for use
sooner. Fill the spa until the water is at the level of
the molded fill line. Do not overfill the spa.
See the inset drawing. Set the Filter (5) and the
Basket (22) in the filter housing. Next, place the
Filter Cover (3) in the filter housing.
4. Pull down one of the straps on the Spa Cover (11)
and hold the Buckle (26) against one of the panels
on the spa. (Note: To position the Buckle correctly,
have a second person hold the strap on the opposite
side of the Spa Cover snug.) The Spa Cover must
be snug. Do not place the Buckle over the
grooves between the premium cedar panels. See
the inset drawing. Remove the latch from the Buckle
(26). Attach the Buckle to the panel with two #4 x 3/4"
Screws (27).
Attach the other three Buckles (26) to the panels in
the same way.
Remove the Spa Cover (11) from the spa.
3
Fill to here
Garden
Hose
4
11
10
3
22
5
Strap
Latch
26
27
Strap
26