Closing The Housing; Using The Camera's Built-In Flash - Ikelite 6165.01 Instruction Manual

Closing the Housing

1. Check to see that there is an
o-ring on the housing back that
is clean and in its proper
location.
2. Guide the back onto the
housing. The o-ring should touch
the housing all the way around.
There should be an even gap all
the way around between the
housing and the housing back.
3. Lift the lid snaps so they are
extended and place the lid snap
into the corresponding hook on the housing back.
4. To close the housing, push down on the lid snaps until they snap into
place. Lid snaps on opposite sides of the housing should be closed at
the same time. Be sure they are down far enough to engage the lid-snap
lock.

Using the Camera's Built-in Flash

If you are shooting with the camera's built-in flash and the camera lens
is set to the widest angle, you may need to zoom the lens slightly or a
dark area may appear in a lower corner of close-up photographs. The
lens port may block some of the light. Install the Diffuser (included) and
zoom in slightly to eliminate any dark areas noted in your photographs
(You can test this above water). See Diffuser/Deflector Installation, page
10. For the best results, we recommend using an external Ikelite
Substrobe.
The camera's built-in flash CANNOT be used with optional Wide-Angle or
Accessory lenses.
8
Even gap on
all four sides
Lid
Snap
Lid Hook
Housing Back
O-ring