Table of Contents
Advertisement
Troubleshooting
Problem
Push buttons or
controls are sticky
and hard to operate
Image is
over/underexposed,
or a corner of the
image is dark
18
Solution
- Remove the camera and rinse the closed housing
in freshwater. Vigorously press each push button
in and out several times to release any trapped
saltwater or debris.
- Press a sticky push button all the way in and
place a small amount of lube on the small end of
the push button shaft at its base. Release and
operate the push button several times to distribute
the lube.
- If a control is sticky, grab the control knob, pull it
out, and then push back in. If still sticky, see the
Control Maintenance section - pages 14 &15.
- Return housing to Ikelite for routine maintenance.
- Check that the camera flash or strobe is firing
when taking a picture. Camera flash should be
forced "on."
- Make sure the deflector is installed when you are
using a non-wired external strobe with a slave.
- Make sure the diffuser is installed when you are
NOT using an external strobe.
- When using an external strobe, make sure it is
turned on, set properly, and its battery is charged.
- Check any corded connection points.
- Change camera shutter speed or aperture.
- Move closer to or further away from the subject.
- Adjust Camera Exp. Comp.
.
Advertisement
Table of Contents
