Diffuser And Deflector Installation And Use - Ikelite 6165.01 Instruction Manual

Diffuser and Deflector Installation
A diffuser and deflector are
included with the housing. The
diffuser is white transparent plastic.
The deflector is also white but is
not transparent.
To install the diffuser or deflector,
push the "Cut-out" Section into the
port groove until it stops.
Note the Small Hole. To avoid
losing the diffuser or deflector, you
can attach a fishing line or string to
this hole.
Diffuser Use
The diffuser should be installed when using the camera flash. When
shooting close-up photographs with the camera flash and at the camera
lens's widest angle setting, the lens port on the housing can block a
portion of the light from the camera flash. This can result in a shadow in
a lower corner of the frame. Zoom the lens to eliminate the shadow (You
can test this above water).
Deflector Use
The deflector should be installed when using any external strobe. The
deflector will block and redirect the camera's flash to an optional slave
strobe or fiber optic cord which will then fire the external strobe. The
deflector also stops the built-in flash from creating backscatter in the
image. Remove the diffuser before attempting to install the deflector.
10
Diffuser/Deflector properly
installed in port groove
Diffuser/Deflector material
Cut-out
Section
Small hole