Control Maintenance - Ikelite 6165.01 Instruction Manual

Control Maintenance

Ikelite controls are designed to provide years of reliable service
with minimal maintenance.
- Push button controls normally require no maintenance other than rinsing
in freshwater after saltwater use. Depress each push button in
freshwater several times to eliminate trapped saltwater. If a push button
control becomes difficult to push or if it sticks when depressed, soak the
housing in luke warm freshwater. After a few minutes, operate the push
button. If this does not correct the problem, return the housing to Ikelite
for maintenance. If you are on a trip and unable to return the housing
immediately, a push button may be lubricated by pressing and holding
the push button all the way in. Then, use your finger or other small
object to place a small amount of lube at the base of the shaft inside the
housing. Press and release the push button several times until the lube
is worked up into the o-ring.
- In the unlikely event one of the control shafts sticks or becomes difficult
to operate, you can remove the control from the housing and lubricate it,
or return the housing to Ikelite for maintenance.
Your housing features both round and hex style control glands. To
remove a control in a round style gland, Diagram E, page 16, loosen
the set screw in the knob (allen wrench required); remove the knob. If
there is salt or dirt build-up on the exposed control shaft, clean the shaft.
Open the housing and gently slide the control shaft out of the control
gland. Clean and lightly lubricate the shaft and o-rings, including the
large end of the shaft.
If there is a shutter spring on the Control Shaft, make sure it is in its
proper position. Rotate the Shaft back and forth slightly to aid installation
back into the Control Gland.
Replace the knob with the Set Screw over the Control Flat. The Set
Screw in the knob should be tightened down against the flat area on the
Control Shaft so the knob does not turn on the shaft.
14