Troubleshooting; Drive Chain - Craftsman 842.242560 Owner's Manual

46" front mounted 2 stage snow thrower attachment
Table of Contents

Advertisement

TROUBLESHOOTING
(
PROBLEM:
Probable Cause -
Possible Remedy
AUGER HOUSING VIBRATION
Failed Bearing -
Bring to Sears Service Center
No lubrication on Drive Chain -
Oil Drive Chain
Damaged Discharge Fan -
Balance or Replace Discharge Fan
CLOGGED DISCHARGE CHUTE
Tractor ground speed too fast -
Use lower Tractor Gear
Tractor Throttle too low -
Use full Tractor Throttle
Snow too deep -
Raise Snow Thrower
DISCHARGE CHUTE IS DIFFICULT TO ROTATE OR WILL NOT HOLD POSITION
Discharge Chute Drive Tube Nut too loose -
Tighten Tube Lock Nut
Chute Control Cable too loose -
Adjust Chute Control Cable Assembly
Discharge Chute and Stack Ring are dry -
Grease all the way around
SNOW THROWER DOES NOT OPERATE
V-Belt too loose -
Replace V-Beft
V-Belt not in Pulley Groove -
Check V-Belt and place back in Groove
Drive Chain rolled or failed -
Reposition and adjust or Replace Chain
Shear Pin Broken -
Replace Shear Pin
BURNED RUBBER SMELL
V-Belt loose or worn -
Replace V-Belt
V-Belt not in Pulley Grooves -
Chuck Pulley And place back into groove
Object jammed in Snow Auger -
Shut Off Tractor, Free Auger
SNOW THROWER WILL NOT LIFT
Adjusting Nuts Loosened -
Adjust And Tighten Nuts
Object jammed between Mounting Frame -
Clear Obstruction
and Tractor
SNOW THROWER KILLS TRACTOR ENGINE
(
Object jammed in Snow Auger -
Clear Snow Auger
Very hard or heavy snow -
Slow Tractor ground speed
Very wet snow -
Increase Tractor Throttle
' - -
- J (
26

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents