Table of Contents
Advertisement
USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART
Spool with 0.065 inch Trimmer Line
Assist Handle
Bolt Carriage, 1/4-20
Wing Nut
Shield Assembly
WARNING:
Perform the follow-
ing steps after each use.
S Stop the unit and disconnect the
power source when not in use.
S Carry the unit with motor stopped.
S Store the unit so the line limiter
blade cannot cause injury.
TROUBLESHOOTING TABLE
WARNING:
Always stop unit and disconnect from the power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
TROUBLE
CAUSE
Trimmer head
1. Crowding trimmer line
stops under a
against material being
load or does not
cut.
turn when switch
2. Electrical failure.
is pressed.
3. Thrown circuit breaker.
4. Debris stopping head.
Line does not
1. Line improperly routed
advance or
in head.
breaks while
2. Line improperly
cutting.
wound into spool.
3. Incorrect line size
4. Not enough line
outside of head.
5. Dirt buildup on unit.
Line welds onto
1. Line size is incorrect.
spool.
2. Incorrect spool.
3. Line is being crowded
against material being
cut.
Line releases
1. Line improperly
continuously.
routed in head.
2. Spool damaged.
Line usage is
1. Line improperly routed
excessive.
in head.
2. Line size is incorrect.
3. Crowding line against
material being cut.
4. Spool worn or damaged.
Line pulls back
1. Too little line outside
into head.
of head.
2. Line size incorrect.
PART NUMBER
C944.510210
530403805
530403886
530016118
530404080
STORAGE
S Store unit and extension cord in-
doors in a high, dry place out of the
reach of children. Store unit un-
plugged.
S Store unit with all guards in place.
Position unit so that any sharp ob-
ject cannot accidentally cause injury.
REMEDY
1. Allow tip of line to do the cutting.
2. Contact Sears Service (see back
cover).
3. Check Breaker Box.
4. Remove debris.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only 0.065 inch (1.65 mm) dia. line.
4. Remove cover and pull 4 inches
(10 cm) of line out of head.
5. Clean unit.
1. Use only 0.065 inch (1.65 mm) dia. line.
2. Replace with correct spool.
3. Cut with tip of line fully extended.
1. Check line routing.
2. Replace spool.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line fully extended.
4. Replace spool.
1. Remove cover and pull 4 inches
(10 cm) of line outside of head.
2. Use only 0.065 inch (1.65 mm) dia. line.
9
Advertisement
Table of Contents
