ASSEMBLY
FIG. 7
FIG.
6
FIG. 5
"
BOLT
3/8 X 1 1/4
WASHER
3/8 LOCK
s
@ .
/
'--~
HEIGHT INDICATOR
"POINTE~
CRANK ROD SUPPORT
ANCHOR
11
MOUNTING
ANCHOR
/NYLOCK NUT
FIG.
4
ASSEMBLE THE CRANK ROD SUPPORT
ANCHOR
•
Remove the plastic cap from height indicator
scale. (See Fig 7)
•
Disassemble and discard 5/16 x 1" bolt that holds
the height indicator scale to the tractor.
•
Remove two 3/8 x 1/2 bolts and the height
indicator pointer from the side of the tractor frame.
•
Position the Crank Rod Support Anchor over the
two holes and secure it with one 3/8 lock washer
and one 3/8 x 1 1/4" bolt in the front hole (See Fig
5)
•
Place the height indicator point over the rear hole
of the Crank Rod Support Anchor and secure it
parallel with one 3/8 lock washer and one 3/8 x I
1/4" bolt.
•
Place 5/16 x 1 1/4" hex bolt through 5/16 lock
washer, one 11/32 x 1 1/2 flat washer, height
indicator scale, one 11/32 x 1 1/2, four 1/8" thick
washers and secure to tractor lift shaft. (See Fig. 6)
•
Reassemble plastic cap.
NOTE; When mower is reassembled to the tractor, the
height indicator scale should be adjusted.
'
•
Remove 3/8" Nylock Nut from the tractor frame.
•
Assemble Mounting Anchor over bolt and
reassemble Nylock Nut While holding Mounting
Anchor at approximately 45 degrees to frame. (See
Fig 4)
•
Repeat the above steps on the right side of the
tractor
ASSEMBLE MOUNTING ANCHORS