Installing The Port - Ikelite Digital Housing Instruction Manual

Installing the Port -

1. To reinstall, first check to see that there is a thin film of lubricant on the
port base o-ring. The o-ring should appear slick. If necessary, relubricate
with the supplied Ikelite lubricant. Do not use excessive lubricant which
can attract hair or other debris. Use ONLY Ikelite lubricant.
2. Make sure the o-ring is free of hair or other debris.
3. The gear sleeve should be in its proper position inside the Port Base
with the teeth facing up. REMOVE the gear sleeve when using the Flat
Port.
4. Slide the Port over the Port Base until it STOPS. When properly
installed, there should only be an approximate 3/32" gap between the
bottom of the Port and the front of the housing, Diagram G, Page 17.
5. Rotate Port so the Shade Extensions are at the 12 and 6 o'clock
position, and the Zoom Knob is opposite the Handle.
6. Snugly tighten the 3 thumb screws into the Port Base. DO NOT
overtighten. No Thumb Screw threads will be visible once the Port is
properly secured.
7. Check zoom function; Not applicable when using the Flat Port.
* Use the same removal/installation procedure for optional 9304.53 Flat
Port. The gear sleeve must be REMOVED before using the Flat Port.
* We recommend placing the closed housing in a pool or bathtub to
assure proper installation and watertightness before installing your
camera.
18
Diagram H, Page 19