Removing The Port - Ikelite Digital Housing Instruction Manual

Removing the Port

The Dome Port never needs to be removed unless replacing the Gear
Sleeve or installing the optional Flat Port.
No tools are needed to remove the Dome Port and attach the optional
Flat Port for the Canon EF-S 60mm Macro lens, Diagram G.
1. Three thumb screws secure the Port on the Base. Turn each thumb
screw counterclockwise so at least 3 to 4 threads are showing.
2. Gently lift the Dome Port off the Port Base, Diagram H, Page 19. If the
Port seems stuck, loosen the thumb screws another turn until the Port
can be removed.
Caution: DO NOT leave the Port off the Port Base for extended
periods of time. This can result in debris being attracted to the port base
o-ring resulting in a bad seal.
Diagram G
Approximately 3/32" gap
will be present between
the Housing Front and
bottom of Port when
the Dome or Flat Port is
properly installed.
Loosen
Tighten
17