Step 3 - Opening The Housing; Step 4 - Installing Camera In The Housing - Ikelite Digital Housing Instruction Manual

STEP 3 - Opening the Housing

Lid Snaps have a Lock.
1. Push Lid Snap Locks forward and lift as shown.
Open opposing Lid Snaps simultaneously. Keep
pressure on the Lid Snaps so they do not fly
open quickly.
Some Lid Snaps have a lot of spring tension
once they go over center, so keep a firm grip on
each Lid Snap. Lid Snaps may also be opened
one at a time.
2. Remove the Housing Back.

STEP 4 - Installing Camera in the Housing

1. Pull out on each housing control until it stops. This will get the controls
out of the way for installation of the camera.
2. Remove camera lanyard from camera if attached.
3. The Mounting Plate is secured to the inside bottom of the housing. The
camera Mounting Tray slides into the Mounting Plate. Use the index and
middle fingers of each hand to pull the Tab section of the Mounting Tray
away from the Mounting Plate, Diagram A. Use your thumbs to apply
opposite pressure against the bottom of the housing to assist in removal.
Diagram A
Pull to Remove
Mounting Tray
Push Forward
Lift
Mounting Plate
Lid
Snap
Lock
9