Installation Preparation; Parts Supplied; Materials You Will Need; Tools You Will Need - Monogram Built-In Dishwashers Installation Instructions Manual

Hide thumbs Also See for Built-In Dishwashers:

Use & care manual (54 pages)

Installation instructions manual (16 pages)

Table Of Contents

Table of Contents

PARTS SUPPLIED IN INSTALLATION

PACKAGE:

• Junction box cover and #10 hex-head screw

• Hose clamp

• Drain hose (approximately 78" long)

• Drain hose hanger

• 2 #8-18 hex head screws to secure brackets to

washer tub frame

• 1 top trim piece

• 2 side trim pieces

• 2 mounting brackets for wood countertops

or side cabinets

• 2 #8-18 x 5/8" Phillips special head screws,

to secure dishwasher to underside of

countertop or to side cabinets

• Literature, samples and/or coupons

MATERIALS YOU WILL NEED:

• 90° elbow (3/4"hose internal thread on one end,

opposite end sized to fit water supply)

• UL-listed wire nuts (3)

• Masking Tape

Materials For New Installations Only:

• Air gap for drain hose, if required

• Waste tee for house plumbing, if applicable

• Electrical cable or power cord depending on your

model, quick connect power cords are availble.

• Screw-type hose clamps

• Strain relief for electrical connection

• Hand shut-off valve (recommended)

• Hot Water Line–3/8" minimum, copper tubing

(including ferrule, compression nut) or GE Part #

WX28X326, flexible braided hose.

• GPF12 or WD24X10065 drain hose (12' long), if needed.

TOOLS YOU WILL NEED:

• Phillips-head screwdriver

• 5/16" and 1/4" nutdriver

• 6" Adjustable wrench

• Level

• Carpenter's square

• Measuring tape

• Safety glasses

• Flashlight

• Bucket to catch water when flushing the line

• 15/16" socket (optional for skid removal)

• Gloves

• Pliers

For New Installations Only:

• Tubing cutter

• Drill and appropriate bits

• Hole saw set