Step 6 Remove Floor Protect; Step 7 Install 90° Elbow; Step 8, Install Drain Hose To Drain Loop; Step 9, Position Water Line And House Wiring - Monogram Built-In Dishwashers Installation Instructions Manual

STEP 6 REMOVE FLOOR PROTECT

• Disconnect leak sensor wire
(on some models).
• Remove 2 screws from front of the
Floor Protect with a ¼" driver.
• Rotate Floor Protect outward and lift
out of the mounting tabs.
• Set aside for use in Step 22.
STEP 7 INSTALL 90° ELBOW
• Thread 90° elbow
onto the water valve.
• Do not overtighten
Water Valve
elbow. Water valve
Bracket
bracket could bend
or water valve fitting
could break.
• Position the end of the
elbow to face the rear
of the dishwasher.
STEP 8
DRAIN LOOP
Connect drain loop end to drain hose using the screw
clamp as shown in the figure.
NOTE: The high drain loop on the side of the tub is
designed for better wash performance. Do not remove
from the side of the tub.
Dishwasher Installation
Squeeze connector at top
to release snap feature
Leak Sensor
Floor Protect
Figure L
Front of dishwasher
90° Elbow
Fill Hose
Figure M
Figure N
8
STEP 9 POSITION WATER LINE AND
• Position water supply line and house wiring on the
floor of the opening to avoid interference with base of
dishwasher and components under dishwasher.
4"
6"
Water
Line
Figure O
STEP 10
• Position dishwasher in front of cabinet opening. Insert
drain hose into the hole in cabinet side. If a power cord
is used, guide the end through a separate hole.
Insulation
Blanket
Tip: Prevent unnecessary service call charges for fill,
drain or noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.
4"
6"
House
Wiring
Maximum Drain Hose
Length 15'
Water
Line
Drain
Hose
House
Wiring
Power Cord
(If Used)
Figure P