Installation - Monogram ZBD9900RII Technical Service Manual

The installation manual and hardware packet are
located inside the machine. The toe kick plate
comes packaged on the top of the Styrofoam
packaging inside the shipping carton.
Snap the plastic glide feet onto the leveling legs to
prevent damage to the fl oor. Please note that the
unit weight is 101 lbs. and the glide feet can mar
some soft wood fl oors. Caution should always be
used when moving a unit into place.
Adjust the door springs
The door should remain balanced once opened.
Both spring ends are turned clockwise to increase
tension, and counterclockwise to decrease tension.
Specifi cations
33-7/8" _ 36"
Height
Width 23 5/8"
Depth 22 7/8" (without door)
Weight 101 lbs
4.2 _ 140 psi
Water Pressure
0.03 _ 1.0 Mpa
0.3 _ 10 Bar
Connection Single phase, 120 V, 60 Hz, 15 A
Max output 1200 W

Installation

PEX water fi ll line
The PEX water fi ll line comes with a 3/8-in.
compression nut that is intended to be connected
to a shutoff valve with compression threads. If the
home shutoff valve has a solder fi tting, cut the
copper water line under the sink and join the copper
and PEX materials with a 3/8-in. compression union.
Drain line
The high loop bracket comes attached to the unit at
the ideal height. It should not be removed.
The drain line bracket can be repositioned to
accommodate an installation or gain hose length
by loosening the set screw and sliding the bracket
along the back top ridge.
The drain line comes with a graduated boot
installed. This graduated boot is designed to
accommodate 1/2-, 5/8-, 23/32-, and 7/8-in.
connections.
The power cord (approximately 42-in. long) comes
already attached to the unit. The terminal block is
set up so that the unit can be hardwired or a longer
cord installed if needed.
– 7 –
Set Screw