To Remove Bogie Wheel; To Remove Bogie Wheel And Support Assembly; To Remove Bogie Wheel Torsion Springs; To Remove Traction Belt Take-Up Assembly J5 - AMF SKI-DADDLER Parts And Service Manual

o
c
c
• During reassembly, torque the locknut (3) to 28
foot-pounds. Be certain the wheel assembly (2) is
installed with grease fittings on the outside.
To
Remove Bogie W heel and Support Assembly
!
CAUTIO~:]
Always disconnect the sparkplugwires
before working on the engine or drive
elements.
• Raise back end of Ski-Daddler so traction belt
clears the ground.
• Remove the screws (1, figure 13) and washers
securing the bogie wheel support · shaft (4) to the
main frame.
• Remove the bogie wheel and support assembly.
• Reassembly is the reverse of removal.
To
Remove Bogie Wheel Torsion Springs
• Remove the bogies as described in paragraph
To Remove Bogie Wheel and Support Assembly.
• Remove the support shaft and separate the bogie
wheel support halves.
• Pry the tabs up sufficiently to remove the torsion
springs. NOTE: The torsion springs are identified
as right- and left-hand springs. Note the direction
of the coils and the position of the springs to facili-
tate reassembly.
• Reassembly is the reverse of removal.
To
Remove Traction Belt Take-Up Assembly
• Remove the rear bOgies. Refer to paragraph To
Remove Bogie Wheel and Support Assembly.
• Release track tension by loosening adjusting
bolts (5, figure 13).
• Release the support arm torsion springs con-.
nected to the main frame .
• Remove the right- and left-hand adjusting angle
locknuts (6), washers and carriage bolts securing
the traction belt take-up assembly to the main
frame.
10024 72
15 .
~I
SERVICE AND REPAIR
le2ia~
• Remove the traction belt take-up assembly as a
unit.
NOTE: The traction belt take-up assembly consi s ts
of the rear spr ocket assembly, spacer and asso-
Ciated hardware held together by the rear support
arm assemblies.
If
necessary to remove seals,
sprockets or idler wheel, proceed as follows.
• Carefully pry the oil seal away fr om the rear
support arm assembly (8, figur e 13) and remove the
support arm and adjusting angl e (9) clear of the
sprocket shaft and bearing.
• Remove the press- on bearings and oil seals.
During reassembly repack bear ings with No. 2
lithium bearing grease.
• Remove the screws (10) and nuts securing the
sprocket plate and the sprocket. to the drive shaft.
Remove the plate and sprocket.
• To remove the idler wheel , r emove the screws
(10) and nuts securing the sprocket plat es and re-
move the idler wheel by stretching the wheel over
the sprocket plates.
• Reassembly is the r everse of r emoval. During
reassembly follow instructions outlined in para-
graphs Track Alignment and Track Tension Adjus t-
ment.
To
Remov e
Sprock et
Seals
and Bearings
• Sprocket seals and bearings are located on each
end of the traction belt take-up assembly and the
drive sprocket assembly drive shafts. To replace
the seals or bearings it will be necessary to remove
the traction belt take-up assembly or the drive
sprocket assembly as des cribed in the applicable
paragraph.
To
Remove Drive Sprocket Assembly
• Remove the hood and headlight assembly and
set
the machine on its right-hand side.
Always disconnect spark plug wires
before working on the engine or drive
elements.
• Remove the locknut secur ing the chain cover and
remove the chain cove r top.