To Remove Engine And Support Assembly-Mark V Only - AMF SKI-DADDLER Parts And Service Manual

o .
Remove the bolts (10, figure 12), spacers and
nuts securing the steering linkage to the steering
column arm (9). During reassembly, apply 15 foot-
pounds torque to the nuts securing the steering
linkage.
c
c
Figure 12
• Remove the bottom cotter pin securing the
steering column to the main f:rame steering column
support.
• On models equipped with an electric starter, dis-
conneCt the wiring harness atthe battery, electrical
panel, taillight and engine. Release the wire V -clips
in the tool box and at the foot rest and remove the
wiring harness. On manual start models disconnect
the wiring harness at the taillight and engine. NOTE:
Replace the metric nut after removing the black
ground lead from the engine.
• Remove the two screws, formed washers and
locknuts at each end of the roll bar and remove the
roll bar, steering column and mini-console as a unit.
• Remove the locknuts and washers securing the
engine mounting straps to the main frame studs,
and remove the engine, engine base and mounting
straps.
• Remove the carriage bolts, nuts and washers
securing the engine mounting straps to the engine
1002472
1, 3
SERVICE AND REPAIR
base. Remove the straps for reassembly. During
reassembly, apply 25-foot-pounds torque to the nuts
securing the engine base.
• Installation is the reverse of removal.
To Remove
Engine
and
Support Assembly-Model
SD15P10B Only
• Remove the hood and headlight assembly. Refer
to Hood Removal and Installation.
Always disconnect the sparkplugwires
before working on the engine or drive
elements.
• Remove the console door assembly by turning
the door fastener counterclockwise to release.
• Remove the six screws, washers and locknuts
securing the console tongue assembly to the tool
box and to the mini-console (see figure 11).
• Remove the drive clutch. Refer to paragraph
To Remove Orive Clutch.
• Loosen the flexible tube clamps securing the
muffler exhaust tube to the engine exhaust manifold
and release the exhaust tubes.
• Disconnect the throttle and choke control cables
and remove the carburetor as described in para-
graph To Remove Carburetor.
• Disconnect the yellow wire lead and the black
wire lead at the engine and the black ground wire
lead at the starter cover. Replace the metric nut
to secure the cover after removing the black wire
lead.
• Remove the heat shield located between the
engine and the muffler. Remove the attaching hard-
ware at the muffler bracket, heat shield bracket and
at the top near the steering column.
• Remove the locknuts and washers securing the
engine mounting straps to the main frame. NOTE:
During reassembly, tighten the locknuts justsuf-
ficiently to permit the washers to be turned by
hand - then tighten the locknuts one additional turn.
• Lift the engine until the engine mounting straps
clear the studs shown in figure 11. Rotate the engine