Table of Contents
Advertisement
FRONT MEASURING
POINTS
Figure
10
Figure
11
3.
Align right hand ski so that it is parallel with
track and replace
spindle
arm on the spindle making
sure that the
splines
are aligned and securely tighten
retaining
bolt.
4. Measure skis front and rear making sure that
both skis are in alignment. If the skis are not in align-
ment with
each
other, adjust tie rod by loosening the
lock nuts and rotating tie rod.
5.
Turn steering handle all the way to the left and
then
check
to
see
that the tie rod end does not stri ke
fiber glass hood
.
Then turn
steering
handle all the
way to the
right
and
check
other tie rod end for same.
POWER TRAIN
TO REMOVE DRIVE BELT
Remove tension from belt by following instructions
under DRIVE BELT ADJUSTMENT. Then remove the belt
guard and use a
screw
driver or similar tool to pry
drive belt off driven sheaves as shown in Figure 12.
Remove other end from drive clutch.
Replace in re-
verse order. After
replacing
drive belt check the belt
tension (See DRIVE BELT ADJUSTMENT).
DRIVE BELT ADJUSTMENT
1.
If the drive belt needs tightening, loosen all bolts
marked
"A"
as shown in Figure 13.
2.
Do not loosen bolts marked "B", (See Figure 13).
3.
Loosen lock nut
"e,
(See Figure 13).
4.
Turn adjusting bolt "0" clockwise. This will pull
the chain
case
forward and tighten the belt. The proper
belt tension is obtained when there is 1 0% inch dis-
tance between clutch
centers
as shown in Figure 13.
Figure 12
Figure 13
5.
Retighten all bolts and nuts.
6.
If the drive belt is
too
tight, which would not
let the belt
come
all the way to the outside of the
sheave on the driving clutch, use the same procedure
as above except turn the adjusting bolt "0" counter-
clockwise which will pu'sh the chain case to the rear.
TO REMOVE CHAIN HOUSING AND
DRIVEN CLUTCH
1.
Remove clutch guard and drive belt as stated
above
.
2.
Loosen bracket at bottom of the chain housing
(See Figure 13).
Use vice grips to hold bolts while
loosening nuts.
Remove only one completely.
Swing
bracket back to free bottom of chain housing.
3.
Remove brake cable from brake arm by remov-
ing the allen
screws
(See
Figure
13).
4.
Remove all fasteners marked "A"
in
Figure 13
to release chain housing
.
5.
Drain chain case through the check plug at the
bottom.
6.
Pry off chain and drive housing with two long
heavy screw drivers or similar tools.
7.
If it becomes necessary to remove chain housing
from the driven clutch, follow instructions under TO
REPLACE DRIVE CHAIN.
8.
Reassemble in reverse order as stated above.
TO REPLACE DRIVE CHAIN
1.
Remove charn housing as stated above.
- 6 -
)
)
)
Advertisement
Table of Contents
