Install Windshield Assembly; Activate Battery - AMF SKI-DADDLER Parts And Service Manual

PREDEL I VERY INSTRUCTIONS
• Install the ski assembly by securing the spring
mounting bracket and spindle pad to lower end of
spindle tube assembly as shown in figure 1. Apply
30 foot-pounds torque to the locknut. Do not over-
tighten bolt as the ski assembly should float freely
on the spindle.
• Repeat procedure for opposite ski.
NOTE: Properly installed skis should toe out 0- to
1/2-inch at the front end (see figure 2) and should
be symmetrical about the centerline of the sled.
To align the skis, refer to the Steering and Ski Align-
ment procedures.
TOE OUTo-TO 1I2-INCH MAXIMUM
Figure 2
Il1stall Windshield Assembly
• Disconnect hood harness at the quick disconnect .
• Remove hood and headlight assembly. Refer to
Hood Removal and Installation procedure.
• Back off the locknut (figure 2) and remove the
7/8-inch length screw used to secure the hood
harness clip and the end of the right-hand mounting
strip to the hood.
• Remove the remaining screws securing the
4
right- and left-hand mounting strips to the hood. "
Remove the mounting strips.
J
• Remove the protective plastic cover from the
windshield. Place the windshield in pOSition on the
hood assembly. Replace the mounting strips as
shown in figure 2.
• Using the original screws, loosely secure the
mounting strips and windshield to the hood assembly
starting at the center and working to the sides. Be
certain to position the 7/8-inch length screw in the
end position shown in figure 2.
• Engage the ends of the mounting strips to the
trim strip on the windshield and then tighten the
screws, starting at the ends and working to the
center. Remove the protective covering from the
mounting strips. NOTE: Check mounting strips for
sharp edges or corners. Use a fine tooth file to
smooth any sharp edges and corners.
• Attach the hood harness clip to the 7/8-inch
length screw and secure with locknut.
Activate Battery-Models SD IBE20B, SDIBE25B and
SD IBE27 A Only )
• Remove the hood and headlight assembly. Refer
to Hood Removal and Installation.
Before activating the 12-volt storage
battery, disconnect the battery cables
and remove the battery. Activate the
battery in accordance with theinstruc-
tions contained on the package con-
taining the electrolite sulfuriC acid.
Reinstall the 'battery as follows:
• Place 12-volt battery on the battery support
plate with positive (+) terminal post forward.
• Attach the negative (-) battery cable (and the
BLACK wire lead from cigarette lighter SD18E20B
only) to the negative terminal post.
NOTE: Cigarette lighter is standard eqUipment on
Model SD18E20B only. May be purchased as an
accessory item for any snowmobile equipped with )
a battery.
1002472