To Remove Muffler; To Remove Bogie Wheel; To Remove Bogie Wheel And Support Assembly; To Remove Bogie Wheel Torsion Springs - AMF 1970 SKI-DADDLER SD15M21 A Parts And Service Manual

C •
Remove the gas tank (4) by carefully sliding the
tank up and away from the main frame. IMPOR-
TANT: Do not damage the gas tank outlet (5) when
removing the tank.
c
c
Do not attempt to make any repairs to
the gas tank. Use extreme care when
removing the gas tank. Do not remove
tank near flame or open fire.
• Gas tank installation procedures are the reverse
of removal. NOTE:
If
the original tank is not to be
installed, it will be necessary to remove the gas tank
outlet (5) and the attached gas line filter; also the
pressure relief valve (7). These items are to be
installed on the replacement tank.
To Remove Muffler
• Remove the hood and headlight assembly. Refer
to Hood RemOVal and Installation.
Always disconnect the sparkplugwires
before working on the engine or drive
elements.
• Loosen the flexible tube clamp securing the
flexible exhaust tube(s) to the muffler and release
the tube. NOTE: On Mark XX 399 and 439 only,
release the springs securing the muffler tubes to
the engine exhaust manifold.
• Loosen the bolt and nut securing the muffler to
the mounting band assembly. Remove the muffler.
• Installation procedures are the reverse of
removal.
To Remove Bogie Wheel
~
Always disconnect the sparkplugwires
before working on the engine or drive
elements.
• Remove the locknut (3, figure 14) securing the
bogie wheel assembly (2) to the axle shaft and re-
move the wheel.
• During reassembly, torque the locknut (3) to 28
foot- pounds. Be certain the wheel assembly (2) is
installed with grease fittings on the outside.
J3
SERVICE AND REPAIR
figure J4
To Remove
Bogie Wheel
and
Support Assembly
Always disconnect the sparkplugwires
before working on the engine or drive
elements.
• Remove the screws (1, figure 14) and lock-
washers securing the bogie wheel support shaft to
the main frame.
• Remove the bogie wheel and support assembly.
• Reassembly is the reverse of removal.
To Remove
Bogie Wheel Torsion Springs
• Remove the bogies as described in paragraph To
Remove Bogie Wheel and Support Assembly.
• Remove the support shaft and separate the bogie
wheel support halves.
• Remove the torsion springs.
NOTE: The torsion springs are iq.entified as right-
and left-hand springs. Note the direction of the
coils and the position ofthe springs to facilitate re-
assembly.
• Reassembly is the reverse of removal.
To Remove Traction Belt Take-Up Assembly
• Remove the rear bogies. Refer to paragraph To
Remove Bogie Wheel and Support Assembly.