c
c
c
• Turn the throttle rod
screw
as required
to adjust
the throttle
control
plate to
the fully open
position
when the throttle control
is
depressed.
• Tighten the locknut
and
jam nut
at the
throttle
arm (figure 10)
to secure
the
throttle
rod
screw.
To Remove Engine and Support Assembly-
Mark VI only
• Remove the hood and headlight
assembly.
Refer
to Hood Removal and Installation.
Always disconnect the
sparkplugwires
before working on
the engine
or
drive
elements.
• Remove the drive
clutch.
Refer to
paragraph
To
Remove Drive Clutch.
NOTE: Figure
5,
Illustrated
Parts List
section of
this manual
contains a
detailed
exploded view of the
engine and
support
assembly
shOwing
all
attaching
hardware.
For
engine maintenance instructions,
refer to the engine manual.
•
Loosen
the flexible tube
clamps securing
the
muffler exhaust
tubes to
the
engine
exhaust
manifold
and
release the exhaust tubes.
• Disconnect the throttle control cable
and remove
the carburetor
as
described
in
paragraph
To Re-
move Carburetor.
• Disconnect the wire leads at the
engine.
• Remove the bolts and washers
securing the
engine
mounting frame to
the
main frame.
• Lift the engine until the engine mounting
frame
clears the shock mounts
and
remove the
engine
toward
the rear of the sled.
•
Remove the bolts and washers securing the
mounting frame to
the
engine base and remove the
mounting frame.
NOTE: During reassembly,
the
mounting frame mqst be secured to the engine base
before reinstalling
the
engine.
•
Installation
procedures
are
the
reverse of
removal.
JJ
VICE AND REPAIR
To Remove Engine and Support
Assembly-
Mark 295
only
•
Remove
the hood
and headlight assembly. Refer
to Hood Removal and Installation.
Always
disconnect the
spark
plug
wire
before working on the
engine or
drive
elements.
• Remove the drive clutch.
Refer to paragraph
To
Remove
Drive Clutch.
NOTE:
Figure 6, Illustrated
Parts
List
section of
this
manual
contains a detailed
exploded
view of
the
engine
and
support
assembly
shOwing all attaching
hardware.
For
engine
maintenance
instructions,
refer to the
engine
manual.
•
Loosen the
flexible
tube clamp
securing
the
muffler
exhaust tube to the engine exhaust
manifold
and
release the exhaust tube.
• Disconnect the throttle control cable
anqremove
the
carburetor
as described in paragraph
To Re-
move Carburetor.
• Disconnect the
wire lead
at the engine.
• Remove the
locknuts
and
washers
securing
the
engine
and
engine
mounting
straps
to the
main
frame.
During reassembly, tighten the
locknuts
sufficiently
to
allow a
5/16-inch
clearance
as shown
in figure 12.
• Lift the engine until the mounting straps clear
the carriage
bolts
and
shock
mounts.
Remove
the
unit toward
the
rear of the
sled.
NOTE: Do
not
remove
the carriage bolts, shock mounts
or
bushings unless
necessary
for replacement.
5
16
HOUNTING
STRAP
SHOCK
HOUNT
Figure J2