Baffle Removal & Installation - Quadra-Fire YOSEMITE-MBK Owner's Manual

E. Baffle Removal & Installation
1. Remove all ash from firebox, and extinguish all hot embers
before disposal into a metal container.
2. Remove ceramic blanket and baffle together.
3. With a 3/16" Allen wrench, remove the front manifold tube
retainer bolts on the air channel under the end of the front
tube. Figure 33.1.
NOTE: Soak the bolts with penetrating oil for at least 15
minutes before trying to remove it.
4. To remove manifold tube, slide the tube to one side until one
end is out of its hole. Then, while lifting that end of the fiber
board baffle, pull tube up over the air channel and out of hole
at the other end.
5. Slide fiber board baffle forward to front of stove and straight
out through door. Figure 33.2.
6. To install the fiber board baffle, repeat steps 2 through 4 in
reverse. Be sure the fiber board baffle and ceramic blanket
are fully pushed back into position and the blanket is down
flat. The front of the blanket should be flush with the front of
the baffle.
Push baffle board up slightly to
allow room to turn the handle
Figure 33.1
Ceramic Blanket
Figure 33.2
December 20, 2011
R
Baffle Board
Baffle Board
7004-187I
Yosemite Wood Stove
Page 33