Section 7: Appliance Set-Up; Door Handle Assembly; Blower Speed Adjustment - Quadra-Fire YOSEMITE-MBK Owner's Manual

7
Yosemite Wood Stove
Appliance Set-Up
A. Door Handle Assemblies
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install additional washer(s) as needed.
4. Install door cam latch and locknut.
Caution! Do not overtighten locknut. Door handle
needs to move smoothly.
5. Install fiber handle turning clockwise to secure it to
door handle shaft.
Handle
Figure 22.1 - Front Door Handle Assembly
Figure 22.2 - Side Door Handle Assembly
Page 22
Lock Nut
Door Cam Latch
Spacing
Washers
Neoprene Washer
Fiber Handle
B. Adjusting The Blower Speed Control
*The blower speed control for this unit is adjusted at the
factory, and normally does not require further adjustment.
NOTE: When the speed control is turned clockwise, it will
click on to high speed. Turn the speed control clockwise
to decrease the speed. At full clockwise, the blower
should blow gently, but should not stop.
1. With the stove plugged in, turn the speed control knob
to slow (full clockwise).
2. With a small screwdriver, adjust the blower speed by
turning the adjustment mechanism through the hole on
the side of the speed control.
3. Adjust the speed so the blower runs slowly, but does
not stop. Turn clockwise to slow the blower and
counterclockwise to increase the speed.
7004-187I
*If Necessary
December 20, 2011
R