Table of Contents
Advertisement
KWO5000
Firmware is stored in a flash memory and can be upgraded easily, using your Web
browser, and can be upgraded via ftp server or ftp server. The currently available
version of KWO5000 is 1.1.11.0.
IP Type
By default, the KWO5000 is configured as static IP Address.
IP Address: The IP address must be unique to your network. The default IP address is
192.168.1.1.
Note
To associate the access point to your PC, make sure the PC IP address need to
be matched the AP. For instance, the KWO5000 is 192.168.1.1, and your PC IP
should be 192.168.1. X.
Subnet Mask
The Subnet Mask must be the same as that set on the LAN that your Access Point is
connected to. The default is 255.255.255.0.
Operating Mode
KWO5000 provides five modes, Access Point, Station, bridge, repeater and
inter-building.
Access Point: Act as a standard 802.11a/b/g. The default mode is Access Point.
Station: Perform as a client station associated to other APs. Be sure that they share the
same SSID when connected.
Bridge
The KWO5000 acts as a bridge connecting APs. Two bridge modes are available
below.
Point-to-Multi-Point Bridge
Select this only if this KWO5000 is the "Master" for a group of bridges. The other
bridge must use this KWO5000 MAC address. They then send all traffic to this
"Master", rather than communicate directly with each other. WEP should be used to
protect this traffic.
Wireless Repeater
In this mode, the KWO5000 can communicate with another wireless station or
wireless bridge. You can enter the MAC address of both adjacent repeaters in the
fields provided to communicate with other wireless bridge or use SSID to
communicate with other wireless station. WEP should be used to protect this
communication.
Wireless Mode: Select the desired wireless operating mode. The default mode is 802.11a /
Advertisement
Table of Contents
