Kyocera ECOSYS P6021cdn Operation Manual page 154

>>ThinPrint over SSL
? On
>LAN Interface
Auto
>LAN Interface
? Auto
Thin Print over SSL (Thin Print over SSL setting)
Select whether or not to use ThinPrintOverSSL.
SSL must be set to [On] in SSL Server (SSL Server setting) on page 4-83.
1
Press  while >ThinPrint On > is displayed. >>ThinPrint
over SSL appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Select On or Off using  or .
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting
is Auto.
1
After entering the administrator ID and password, press  or 
repeatedly until >LAN Interface appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Press  or  to select the desired LAN Interface. The available LAN
Interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
1000Base-T
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
Security Level (Security Level setting)
Security Level is primarily a menu used by service personnel for
maintenance work. There is no need for customers to use this menu.
4-86
Using the Operation Panel