Cautions On Wiring; Sample Systems - Clarion CMD8 Owner's Manual & Installation Manual

1. Insert the source unit into the cutout hole until to the end. (Figure 5)
2. Using the supply screws (4 × 30) to secure the source unit. (Figure 5)
3. Using support strap to secure the source unit on the back side by supply M4 nut.
(Figure 5)
Notes:
1. Some boat models require special mounting kits for proper installation.
Consult your Clarion dealer for details.
• Remove CD mech lock-screw.
• Stick Hole block seal for hole of
lock-screw.
4 × 30 Screws
Rubber Gasket
4 × 30 Screws
Figure 5
Support Strap
M4 Nut
M4 washer
Source unit
Support Strap
M4 Nut
M4 washer
Stud Bolt
Note:
Confirm that the rubber gasket is fastened securely to the base
panel.

6) Cautions on Wiring

1. Be sure to turn the power off when wiring.
2. Be particularly careful where you route the wires.
Keep them well away from the engine, exhaust pipe, etc. Heat may damage the wires.
3. If the fuse should blow, check that the wiring is correct.
If it is, replace the fuse with a new one with the same amperage rating as the original one.
4. To replace the fuse, open the lock on the source unit side, remove the old fuse and insert the
new one. (Figure 6)
* There are various types of fuse cases. Do not let the battery side terminal touch other metal
parts.
Fuse case
Figure 6

7) Sample Systems

6
7
1
2
2 8
3
Fuse
1 Source unit
2 RCA extension cable (sold separately)
3 4-Channel power amplifier
4 Front speakers
4
5 Rear speakers
6 Wired remote control unit
7 SiriusXM-Connect Vehicle Tuner
8 AUX
5
CMD8
17