Performing Installation Cycle - Electrolux Front load washer Installation Instructions Manual

Performing Installation Cycle

With your washer in fi nal location, perform an Installation Cycle to assist in proper installation.
If your washer has this console:
1. Empty washer's drum and close door.
2. After you plug in the washer the fi rst time: wake up
the washer by pressing any button, rotate cycle knob
to cycle one up from lower right position (1), press the
start button (3) and then the cancel button (4).
3. Wake up the washer again by pressing any button,
then immediately and simultaneously press and hold
buttons 2a and 2b for 5 seconds, or until the LCD
display changes.
4. The LCD window will display INSTAL CYCLE and
show estimated time of cycle completion. Press the
start button (3). The Installation Cycle will automati-
cally perform various diagnostic routines. At cycle
completion, the LCD window may display INSTAL
PASS!, meaning your new washer is properly installed
and ready for use. If it prompts an action such as NO
WATER, CHECK HOSES or CALL SERVICE
877 435 3287, review the installation steps and
make the necessary corrections before you attempt to
use the washer.
5. Your washer will exit the Installation Cycle and return
to normal operation the next time you wake it up.
6. Please read the Use & Care Guide and enjoy your new
premium washer!
NOTE
Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the washer
through a washing cycle, press the cancel button to put the unit to sleep and then rewake it immediately
to continue the normal operating mode.
Installation Instructions
2a
2b
1 3 4
If your washer has this console:
1. After you plug in the washer the fi rst time: wake up
the washer by pressing any button and then follow the
prompts on the LCD User Interface, including lan-
guage selection.
2. The Installation Cycle will automatically perform vari-
ous diagnostic routines. At cycle completion, the LCD
window may display INSTAL PASS!, meaning your
new washer is properly installed and ready for use. If
it prompts an action such as NO WATER, CHECK
HOSES or CALL SERVICE 877 435 3287,
review the installation steps and make the necessary
corrections before you attempt to use the washer.
3. Your washer will exit the Installation Cycle and return
to normal operation the next time you wake it up.
4. Please read the Use & Care Guide and enjoy your new
premium washer!
11