Table of Contents
Advertisement
Wave-Touch™ Installation Cycle
1. After plugging in the washer the first time:
wake up the washer by pressing any button
and then follow the prompts on the LCD User
Interface, including language selection. The
Installation Cycle will automatically test for if
the water has been turned on.
2. At cycle completion, the LCD window may
display INSTALL PASS!, meaning the washer
is properly installed and ready for use. If it
prompts an action such as NO WATER,
CHECK HOSES or CALL SERVICE 877-435-
3287, review the installation steps and make
the necessary corrections before attempting to
use the washer.
3. The washer will exit the Installation Cycle and
return to normal operation the next time the
washer is used.
NOTE
Washer will stay awake for 3 minutes after
the Installation Cycle. If you wish to immedi-
ately run the washer through a washing
cycle, press the cancel button to put the unit
to sleep and then rewake it immediately, to
continue the normal operating mode.
Installation Information
IQ -Touch™ Installation Cycle
1. Empty washer's drum and close door.
2. After you plug in the washer the first time:
wake up the washer by pressing any button,
rotate cycle knob to hand wash cycle, press
the start button and then the cancel button.
3. Wake up the washer again by pressing any
button, then immediately and simultaneously
press and hold both the eco friendly and my
favorite buttons for 5 seconds, or until the LCD
display changes.
4. The LCD window will display INSTAL CYCLE
and show estimated time of cycle completion.
Press the start button. The Installation Cycle
will automatically test for if the water has been
turned on. At cycle completion, the LCD
window may display INSTAL PASS!, meaning
the washer is properly installed and ready for
use. If it prompts an action such as NO
WATER, CHECK HOSES or Call Service 877-
435-3287, review the installation steps and
make the necessary corrections before you
attempt to use the washer.
5. The washer will exit the Installation Cycle and
return to normal operation the next time the
washer is used.
NOTE
Washer will stay awake for 3 minutes after
the Installation Cycle. If you wish to immedi-
ately run the washer through a washing
cycle, press the cancel button to put the unit
to sleep and then rewake it immediately, to
continue the normal operating mode.
2-11
Hide quick links:
Advertisement
Table of Contents
