Installation Instructions; Leveling Your Washer; Connecting Inlet Water - Electrolux Front load washer Installation Instructions Manual

Leveling your washer

Excessive noise and vibration can be prevented by
properly leveling the washer.
1. For free standing installation and with the washer
within 4 feet (1 m) of its fi nal location, place a level
on top of the washer.
2. Use the universal wrench to adjust the leveling
legs so the washer is level front-to-rear and side-
to-side, and stable corner-to-corner.
3. Press down on alternate corners and sides and
feel for the slightest movement. Adjust the appro-
priate leg(s) so the washer sits solidly on the fl oor
on ALL four legs. Keep the leveling leg extension
at a minimum for best performance of the washer.
NOTE
For pedestal installations, see additional installation
instructions included with the pedestal.

Connecting inlet water

1. Run some water from the hot and cold faucets to
fl ush the water lines and remove particles that might
clog the water valve screens and to determine which
faucet is hot and which is cold supply.
RUBBER WASHERS
MUST BE PRESENT
NOTE
Hoses are not included with washer purchase. See
"Accessories" section for various inlet hose kits to fi t
your specifi c installation.
2. Connect the HOT inlet hose to the HOT inlet con-
nection on the washer and the COLD inlet hose to
the COLD inlet connection on the washer. Tighten by
hand until snug. Then tighten each supply connec-
tion another 2/3 turn with pliers. Do not cross thread
or over-tighten these connections.
3. Connect the HOT inlet hose to the HOT water supply
and the COLD inlet hose to the COLD water supply.
Tighten by hand until snug. Then tighten each supply
connection another 2/3 turn with pliers. Do not bend,
kink or pinch water inlet hoses.
4. Turn on the water and check for leaks.

Installation Instructions

a
a
USE ONLY NEW
HOSES
HOT
b
raise
c
c
COLD
e
g
lower
d
b
d
f
9