Installing The Cabinet; Anti Tip Bracket Considerations - AGA marvel M36SS Operating And Maintenance Instructions Manual

When planning your rough in opening a 3" (7.6cm) re-
movable filler panel is recommended above the grille. To
remove the power module from the cabinet the front has to
be tilted up as shown in Figure 7 when removed for service.
-3" (7.6cm) removable filler
recommended
84 ⁄ "
5
8
(214.9cm)
Maximum

INSTALLING THE CABINET

Figure 7
Anti - tip Bracket considerations
Before placing the cabinet in opening, the depth of the
cut-out opening should be at least 24" (61cm). If the cut-out
opening depth is more than 24" (61cm), then a piece of
wood must be secured crosswise on the wall into the studs
at the height of the anti-tip brackets. (See Figure 9). Slide
the cabinet into position and level the cabinet with adjust-
able rear roller and front leveling legs. (See Leveling the
unit on page 11).
Locate a wall stud behind the unit that is suitable for secur-
ing the 5" (12.7cm) anti-tip bracket to the wall. The position
of the bracket should be to the right of the power module
and not behind the power module. Do not disturb the power
module gasket on the left side of the unit. Place the anti
tip bracket on top of the cabinet flush with the back of the
cabinet. Mark and drill at least three holes (
the top of the cabinet and secure the bracket to the top of
the cabinet with at least (3) of the #8 x
Secure the bracket to the wall stud with at least (2) #8 x
1 ⁄ " screws provided. See Figure 8.
1
2
Figure 8
Crosswise
lumber-
10
⁄ " (3.2mm) into
1
8
⁄ " screws provided.
5
8
-Wall stud
-Anti - tip
bracket
on top of
cabinet
-At least 2
screws into
wall stud.
-Leave
access for
water line if
required.
Figure 9