Installing The Cabinet; Anti Tip Bracket Considerations - AGA marvel M24AR Installation, Operating And Maintenance Instructions

M24ar/m30ar/m36ar series built in all refrigerator

Hide thumbs

Table of Contents

Available languages

Anti - tip Bracket considerations

Before placing the cabinet in opening, the depth of the

cut-out opening should be at least 24 inches. If the cut-

out opening depth is more than 24 inches, then a piece of

wood must be secured crosswise on the wall into the studs

at the height of the anti-tip brackets. (See Figure 8 and 10).

Slide the cabinet into position and level the cabinet with

adjustable rear roller and front leveling legs. (See Leveling

the unit on page 12).

24" wide refrigerator:

The anti tip bracket is fastened to the cabinet and runs the

full width of the cabinet. Locate a wall stud behind the cabi-

net and secure the anti-tip bracket with at least (2) #8 x 1

screws provided. See Figure 7.

30" and 36" wide refrigerators:

Locate a wall stud behind the unit that is suitable for secur-

ing the 5" anti-tip bracket to the wall. The position of the

bracket should be to the right of the power module and not

behind the power module. Do not disturb the power module

gasket on the left side of the unit. Place the anti tip bracket

on top of the cabinet flush with the back of the cabinet.

Mark and drill at least three holes (1/8" (3.2mm) into the

top of the cabinet and secure the bracket to the top of the

cabinet with at least (3) of the #8 x

cure the bracket to the wall stud with at least (2) #8 x 1

screws provided. See Figure 9.

Figure 7

24" wide refrigerator