IEI Technology AFL-W15A-GM45 User Manual page 55

NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
Flow Control [None]
Use the Flow Control option to report the flow control method for the console redirection
application.
None
Hardware
Software
Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.
Disabled
Boot Loader
Always
Terminal Type [ANSI]
Use the Terminal Type BIOS option to specify the remote terminal type.
ANSI
VT100
VT-UTF8
Page 44
AFL-W15A/17D-GM45 Panel PC
No control flow,
D
EFAULT
Hardware is set as the console redirection
Software is set as the console redirection
The console is not redirected after POST
Redirection is active during POST and during Boot
Loader
Redirection is always active (Some OSes may not
D
EFAULT
work if set to Always)
The target terminal type is ANSI
D
EFAULT
The target terminal type is VT100
The target terminal type is VT-UTF8