Set-Up Instructions - Gold Note VALORE Compact Owner's Manual

VALORE Compact
Italian Prestige Rigid Turntable
1) Please remove carefully all the protecting foam and check the items listed are all supplied.
2) Place the VALORE Compact deck on a levelled surface you have chosen for it. We recommend a wall shelf, as they are the most
sturdy, and immune to footfall, but a well-made equipment rack should give satisfactory results also. Once the table deck is
placed on your chosen set-up location you are now ready to continue.
3) The DIN/RCA cable of the arm is installed on the shaft female connector ready to be hooked to the amplifier.
4) Install the counterweight into the rear arm wand of the B-5sc till it touches the rubber ring that is set for the right weight of the
cartridge pre mounted.
5) Be sure to level the platter both front to back, and side-to-side!
6) Install the belt on the preferred speed groove.
Your VALORE COMPACT turntable has been designed for sheltered Hi-Fi systems. It must be protected from any eventual variations in
temperature and humidity. Avoid using in the vicinity of radiators or other strong heat sources, electrical and electronic motors, mobile
phones etc.
The location in proximity of other audio components is not theoretically critical, but you should nevertheless pay attention to this.
The levelling and positioning on a solid, firm board, as explained in the previous chapter, are fundamental elements to ensure the maximum
sonic performances.
PLEASE NOTE: Check that the correct acceptance voltage is indicated on your turntable. Incorrect voltage will prevent your VALO PLEA PLEA PLEA SE NOTE: Check that the correct acceptance voltage is indicated on your turntable. Incorrect voltage will prevent your VALO SE NOTE: Check that the correct acceptance voltage is indicated on your turntable. Incorrect voltage will prevent your VALO SE NOTE: Check that the correct acceptance voltage is indicated on your turntable. Incorrect voltage will prevent your VALORE
COMPACT from working properly and could risk causing irreparable damage. COMPACT from working properly and could risk causing irreparable damage. COMPACT from working properly and could risk causing irreparable damage. COMPACT from working properly and could risk causing irreparable damage.
WARNING: Never turn on the turntable while any parts are disassembled, as contact with the high voltage inside the VALORE WARNING: Never turn on the turntable while any parts
WARNING: Never turn on the turntable while any parts WARNING: Never turn on the turntable while any parts
COMPACT turntable could be fatal. COMPACT turntable could be fatal.
COMPACT turntable could be fatal. COMPACT turntable could be fatal.
By positioning the belt in the smaller groove of the synchronous pulley motor, the VALORE COMPACT turntable be set at 33 1/3 rpm,
while in the larger groove it will be set at 45 rpm. This positioning must be carried out manually.
The pulley may be covered by a Jewellery Gold Plated cover available as optional.
The On/Off switch is located on Acrylic board. Once the switch has been turned to ON (1) the turntable will start working at the speed
hand selection.
Set-Up Instructions - Positioning – Operating
Set Set- - - - up Instructions up Instructions
Set Set up Instructions up Instructions
Positioning the VALORE Compact Positioning the VALORE Compact
Positioning the VALORE Compact Positioning the VALORE Compact
are disassembled, as contact with the high voltage inside the VALORE
are disassembled, as contact with the high voltage inside the VALORE are disassembled, as contact with the high voltage inside the VALORE
33 1/3 rpm or 45 rpm 33 1/3 rpm or 45 rpm
33 1/3 rpm or 45 rpm 33 1/3 rpm or 45 rpm
Turning on Turning on Turning on Turning on
RE RE RE
5