GE Side by Side Refrigerators Installation Instructions Manual page 21

ZKHSS2 Tubular Stainless Steel Handles
STEP 2 INSTALL HANDLE ONTO PANELS
Drill Pilot Holes
the handle side edge, top to bottom.
centered top to bottom and on the marked line.
of the handle attachment posts. Place the handle
over the marks to check again that the holes are
aligned to the handle posts.
pilot holes from the appearance side and through
the entire panel thickness.
on the opposite door.
CAUTION: Hole locations must be exact to
accept handle standoff and handle assembly.
Assemble Handles
the handle. Position the screw hole on the standoff to
point to the floor.
be tight against the handle.
STEP 2 (continued)
Secure Handles to Panels
into the back side of the panel. At this depth there
will be enough screw threads to engage the handle
on the appearance side. See the illustration below.
through the spacer.
screws on the appearance side, then drive the top
screw partially into the standoff.
Alternate back to the top tightening screws one
at a time until the handle is tight against the panel.
21
Countersink
screw into
panel as shown.