LevelOne FCS-1020 User Manual page 40

Subnet Mask
Default Gateway
DNS Server
Video Port Number
Control Port Number
Camera Name
Firmware Version
Apply
Change Password
Old Password
New Password
Confirm New Password
Apply
range for the camera, for example: 192.168.2.250.
The Subnet Mask field must match the subnet setting on your
LAN. For example: 255.255.255.0.
The Gateway is used to forward frames to destinations in a
different subnet on the Internet. The Gateway setting must match
the values used by the PCs on your LAN.
DNS Server (Domain Name Server) that translates names to IP
addresses. Set the same values as the PCs on your LAN.
The Video Port is used to transmit or receive the video streaming
in the network. The default port setting is "4321". If you want to
view the video from the camera, the port setting should be
correct.
This camera support web connection, the default web port is 80.
Since the web server may use port 80, you can use a different
port for the camera. If you change the web port from 80 to 8080,
you must type http://192.168.2.3:8080
through the web browser.
The default camera name is "FCS-1020". It is recommended to
name a meaningful name for the camera.
Display the current firmware version of the camera.
When you finish the "IP Setting", click "Apply".
Enter current password.
Specify the new password you want to change to.
Enter the new password again for confirmation.
When you finish the "Change Password", click "Apply".
40
to connect the camera