Gateway
Video Port
Cancel
Finish
When you finish the camera setting, you can click "Ok" to run the "Camera Viewer"
immediately or click "Cancel" to run the "Camera Viewer" later.
7.
Using the Camera Viewer
7.1.
Panel Introduction
In the beginning when you start the view, you would see a Control Panel and a four division
Viewer window.
The wizard will auto search the Gateway setting of the network
and set the camera to use the same Gateway.
You can enter another Gateway to change the setting.
It defines the video stream port. The default value is "4321".
Click "Cancel" to stop wizard setting.
Click "Finish" to complete the camera setting.
21