Automation Enables; Automation Suspend - CM Labs Workstation Console Owner's Manual

Using the Automation Modes
First, put the BURN switches in "write" mode as
described earlier. Then, enable the parameter type for
automation and make sure "Suspend" is off.
Off Mode
If a channel is in "off" mode, then no automation will play
on that channel, and no updates will be made to the
automation on that channel.
Read Mode
If a channel is in "read" mode, then automation will play
on that channel, but no updates will be made to the
automation on that channel.
Touch Mode
If a channel is in "touch" mode, rotate the channel rotary
pot, and the parameter change will be punched in. If you
stop moving the pot, it will drop back after the touch
time-out has elapsed (set as an automation preference in
software).
Latch Mode
If a channel is in "latch" mode, you can either rotate the
channel rotary or press the channel BURN switch to
punch in an automation move.
Write mode
If a channel is in "write" mode, any parameter change
made during play will be updated until play is stopped.

Automation Enables

Press and hold the ENABLE, and the LCD will display
"FADR MUTE PAN SEND SENDM PLUG-IN SUSP".
The SELECT LED's will show the current state for these
enables, and the SELECT switches toggle them on and
off.
Enable Fader Automation
If the FADR LED is on, then fader level changes will be
updated in the automation.
Enable Mute Automation
If the MUTE LED is on, then mute changes will be
updated in the automation.
Enable Pan Automation
If the PAN LED is on, then pan setting changes will be
updated in the automation.
Enable Send Level Automation
If the SEND LED is on, then send level changes will be
updated in the automation.
Enable Send Mute Automation
If the SENDM is on, then send mute changes will be
updated in the automation.
Enable Plug In Automation
If the PLUG-IN is on, then plug-in parameter changes will
be updated in the automation if the particular plug-in
parameter has been automation enabled in the plug-in
window.

Automation Suspend

If the SUSP led is blinking, then automation playback
and updating has been disabled globally. This switch
duplicates the function of the "susp" switch in the
PUNCH mode for the MULTI row of switches on
MotorMate. All channel mixer settings are left in their
current state and the channel automation mode is
unchanged, but "dormant".
CM Labs MotorMate Owner's Manual
Mixer Controls
Page 19