Other Multi Switch Functions; Audition; Pre Roll; Out - CM Labs Workstation Console Owner's Manual

Other MULTI Switch Functions

PUNCH

Press the third Multi Mode switch,
and the PUNCH LED will light. The
MULTI switches then will activate
the functions labelled below them.
The left most 5 switches are the audition switches. These
are labelled AUD (audition), PRE (pre roll), IN (edit
selection start), OUT (edit selection end), and POST

(post roll).

AUD
Press the AUD switch and the LED will light and the
audition features of the software become active. Audition
followed by combinations of PRE, IN, OUT, or POST
allows the user to audition in and around an edit point.
Audio playback in progress will continue until AUD is
pressed again to disable it.
PRE
Press the PRE switch to play from the pre-roll point to
the start of the edit selection. This mimics the option -
left arrow on the keyboard.
IN
Press the IN switch to play from the start of the edit
selection and play the length of the pre-roll. This mimics
the command - left arrow on the keyboard.
If you press the IN switch while playing, it enters the
selection IN point on the fly.

OUT

Press the "out" switch to play from the end of the edit
selection and play the length of the post-roll. This mimics
the option - right arrow on the keyboard.
If you press the OUT switch while playing, it enters the
selection OUT point on the fly.
POST
Press the POST switch to play from the end of the edit
selection and play the length of the pre-roll. This mimics
the command - right arrow on the keyboard.
Press and hold ALT and OPT on the keyboard together
and then press PRE or IN and play will go from the pre-
roll point through the edit selection and end after the
post-roll time. This mimics the command - option - left
arrow on the keyboard.
Press and hold the keyboard ALT and OPT on the
keyboard together and then press OUT or POST and
play will go from before the edit selection end by the pre-
roll amount through the edit selection and end after the
post-roll time. This mimics the command - option - right
arrow on the keyboard.
When audition is active, you can press any of the other
audition switches and instantly go from auditioning one
selection to another.
PNCH, LOOP, and SUSP
To the right of the 5 audition switches are the PNCH,
LOOP and SUSP switches.
PNCH
Press the PNCH switch to enable auto punch.

LOOP

Pressing the LOOP switch will cause the edit selection to
play from start to end (in to out) and then repeat
continuously. To activate loop record, press and hold
CTRL on the keyboard and then press LOOP.
SUSP
Press the SUSP switch, and automation playback will be
suspended. When automation is suspended, the SUSP
LED will blink on and off.
CM Labs MotorMate Owner's Manual
Mixer Controls
Page 17