Handlebar Switches - Yamaha FZS10A Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
This function allows you to adjust the
brightness of the LCD and the tachom-
eter panel and needle to suit the out-
side lighting conditions.
To set the brightness
1. Turn the key to "OFF".
2. Push and hold the "SELECT" but-
ton.
3. Turn the key to "ON", and then re-
4 lease the "SELECT" button after
five seconds.
4. Push the "RESET" button to select
the desired brightness level.
5. Push the "SELECT" button to con-
firm the selected brightness level.
The display will return to the prior
mode.

Handlebar switches

Left
1. Dimmer switch " / "
2. Turn signal switch " / "
3. Horn switch " "
4. Hazard switch " "
Right
1. Engine stop switch " / "
2. Start switch " "
4-9
EAU12348
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12400
/ "
" for the high
EAU12460
/ "
". When re-
EAU12500
"
EAU12660
/ "
" before starting
" to