Cancelling The Auto Restart Function; Power Failure During Timer Operation - Toshiba RAS-07PKVP-E Service Manual

Split type
Hide thumbs Also See for RAS-07PKVP-E:
Table of Contents

Advertisement

High Wall, Heat Pump Type
When the unit is operating
The unit is in operation.
(Push [RESET] button
for more than 3 seconds.)
The unit stops operating.
(After approx. 3 seconds)
The unit beeps three times.
If the unit is required to operate at this time, push
[RESET] button once more or use the remote controller
to turn it on.
NOTE
• After restarting the air conditioner by the AUTO
RESTART OPERATION, the louver swing (AUTO)
operation doesn't resume.
• While the PURE indicator (Orange) is on, the
RESET button has the function of air purifier reset
button.
8-21-2. Cancelling the Auto
Restart Function
To cancel auto restart function, proceed as follows:
1) Repeat the setting procedure: the unit receives
the signal and beeps three times.
2) The unit will be required to be turned on with
the remote controller after the main power
supply is turned off.
Push [RESET] button for more than three seconds.
(Less than 10 seconds)
The green indicator is on.
The green indicator turns off.
The green indicator
flashes for 5 seconds.
When the unit is stand-by (Not operating)
The unit is on standby.
(Push [RESET] button
for more than 3 seconds.)
The unit starts to operate.
(After approx. 3 seconds)
The unit beeps three times
and continues to operate.
If the unit is not required to operate at this time, push
[RESET] button once more or use the remote controller
to turn it off.
When the unit is operating
The unit is in operation.
(Push [RESET] button
for more than 3 seconds.)
The unit stops operating.
(After approx. 3 seconds)
The unit beeps three times.
If the unit is required to operate at this time, push
[RESET] button once more or use the remote controller
to turn it on.
8-21-3. Power Failure During
Timer Operation
When the unit is turned off because of power failure
during timer operation, the timer operation is cancelled.
In that case, set the timer operation again.
NOTE
The Everyday Timer is reset while a command signal
can be received from the remote controller even if it
stopped due to a power failure.
53
Service Manual
The green indicator is on.
The green indicator is on.
The green indicator turns off.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents