Download Table of Contents Print this page

Rinse Aid; Setting Amount Of Rinse Aid; Switching Off Rinse Aid Refill Indicator - Siemens Dishwasher Operating Instructions Manual

Dishwasher siemens


Table of Contents

Rinse aid %

As soon as the rinse-aid refill indicator @
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
– Open the dispenser 1b by pressing
and lifting the plate on the cover.
– Carefully pour rinse aid up to the max.
mark in the filler opening.
– Close cover until it clicks shut.
– To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a

Setting amount of rinse aid

The amount of rinse aid can be set from
to :
to obtain very good drying results
( :
Change this setting, only if streaks (select
lower setting) or water stains (select higher
setting) are left on the utensils.
– Close the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button ` until : .... is
indicated on the digital display.
– Release both buttons.
– Press programme button # until the
factory set value :
the digital display )".
To change the setting:
– Press programme button 3.
Each time the button is pressed, the
set value increases by one level; when
the value of :
the display jumps back to :
– Press START button `.
The set value is saved.
Switching off rinse aid refill
If the rinse-aid refill indicator @ is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
– Proceed as described under "Setting
amount of rinse aid" and set the value
to :
The rinse aid refill indicator @ is now
switched off.
. Please set rinse aid on
is already set in factory).
has been reached,
is indicated on


Table of Contents

Table of Contents