Sensor Adjust - Python 5206P Owner's Manual

Press and hold the
1.
mit LED turns on constant.
Press and hold the
2.
flashes twice and comes on solid.
Note: The remote automatically exits the programming mode af-
ter 30 seconds if no action is performed.
Press and hold the
3.
With the Responder LE remote: The siren chirps and the remote
emits tones to confirm that pairing is successful. If the siren does
not chirp or the remote does not emit tones then pairing has
failed, repeat step 3.
With the 1-way remote: The siren chirps to confirm the remote
has successfully paired to the system.
Turn off the vehicle ignition to exit the pairing mode once the
4.
remote has been successfully paired to the system.
The pairing routine exits if any of the following occurs:

Sensor Adjust

To avoid unintended alarm triggers; it is recommended that an autho-
rized Directed Dealer performs all sensor adjustments.
© 2012 Directed. All rights reserved.
button on the remote control until the trans-
button on the remote until the transmit LED
button.
23