Table of Contents
Advertisement
menu #2
FEATURE
DEFAULT - LED ON SETTING
NUMBER
(PRESS CHANNEL 1)
2-1
Engine check ON
2-2
Tachometer engine check
2-3
12 minutes run time (1)
2-4
Flashing parking light output
2-5
Cranking time 0.6 sec. (1)*
2-6
Voltage check high level
2-7
Short run (turbo) 1 minute (1)
2-8
Activation pulse: 1 (1)
2-9
2nd Ignition output
2-10
Accessory state during wait to start OFF
2-11
2nd status output NORMAL (1)
2-12
Anti-Grind ON
2-13
Diesel timer Wait-to-Start input (1)
2-14
Run Time (Timer Mode) 12 minutes (1) 3 (2), 6 (3), 9 (4) minutes
*NOTE: The numbers in parentheses indicate the number of times the LED will flash.
feature descriptions
The features of the system are described below. Features that have additional settings that can be selected only
when programming with the Bitwriter are indicated by the following icon:
menu #1
1-1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when the transmitter
is used. When set to passive, the system will arm automatically 30 seconds after the last door is closed. To alert
the consumer of passive arming, the siren will chirp 20 seconds after the door is closed. This provides the con-
sumer with an audible warning prior to the system actually arming. At the 30 second mark, the system will arm,
but the siren will not chirp.
36
LED OFF SETTING
(PRESS CHANNEL 2)
Engine check OFF
Voltage engine check
24 minutes (2), 60 minutes (3) run time
Constant parking light output
Cranking time 0.8 (2), 1.0 (3), 1.2 (4), 1.4 (5),
1.6 (6), 1.8 (7), 2.0 (8), 4.0 (9) sec.*
Voltage check low level
3 (2), 5(3), 10 (4) minutes
Activation pulses: 2 (2), 3 (3)
2nd Accessory output
Accessory state during wait to start ON
Rear defogger latch (2), rear defogger pulse (3)
Anti-Grind OFF
Timed 15 (2), 30 (3), 45 (4) seconds
© 2006 Directed Electronics—all rights reserved
Advertisement
Table of Contents
