LevelOne WBR-3408 User Manual page 25

Setup
Downloaded from www.Manualslib.com
SSID 1/2 This is also called the "Network Name".

If using an ESS (Extended Service Set, with multiple access
points) this ID is called an ESSID (Extended Service Set
Identifier).

To communicate, all Wireless stations should use the same
SSID/ESSID.
If enabled, the Wireless ADSL Router will broadcast its SSID.
Broadcast
This allows PCs and other wireless stations to detect this Access
SSID
Point and use the correct SSID.
If disabled, PC users will have to manually enter the SSID and
other details of the wireless interface before they can connect to
this Access Point.
Isolation within If Enabled, devices that have the same SSID will not be able to
see each other.
SSID
The current Wireless security is displayed. The default value is
Security Set-
Disabled.
ting
Click this button to access the Wireless security sub-screen, and
Configure SSID
view or change the settings. See the following section for details.
1/2 Button
Options
Select the desired mode:
802.11 Mode

Off - Wireless is disabled.

B only - Only 802.11b connections are available. 802.11g
Wireless Stations will only be able to use the Wireless Rou-
ter if they are fully backward-compatible with the 802.11b
standard.

G only - Only 802.11g Wireless stations can use the Wire-
less Router.

11b/g - 802.11b and 802.11g Wireless stations can use the
Wireless Broadband Router.
Select the Channel you wish to use on your Wireless LAN.
Channel NO.

If you experience interference (shown by lost connections
and/or slow data transfers) you may need to experiment with
different channels to see which is the best.

If using multiple Access Points, adjacent Access Points
should use different Channels to reduce interference.
If Enabled, devices that have the different SSIDs will not be able
Isolation
to communicate with each other.
between SSID
Enable by default.
WMM Support
Bandwidth Select the desired bandwidth from the list.
manuals search engine
25