Replace As Required; Indicator Is Red; Drain Cooling Water From Gearbox To Prevent Rust And/Or Freeze Damage; Check The Water Spray Over The Diamond Blade - Husqvarna FS5000 D Operator's Manual

Check all hoses and clamps for damage or
looseness.
The image only shows some of the hoses and clamps.
• Look for leakage on fuel, hydraulics and cooling system.
Tighten or replace as necessary.
Check air cleaner restriction indicator.
• Check and clean the outer air filter if the air cleaner
indicator is red, remove the rear cover by opening the 3 air
filter housing clamps and pulling the housing off.
• Clean the filter by blowing the element from inside out.
Use the lowest possible air pressure to remove the dust
without damaging the element.
Use 42-47 PSI (0,29-0,49 MPa;3,0-5,0 kgf/cm
compressed air to remove particulates.
MAINTENANCE AND SERVICE
2
)
• Replace any damaged filters or gaskets and check air
hose and clamps for damages or looseness. Tighten or

replace as required.

NOTICE! No need to clean the inner filter on a daily basis.
The 3 air filter housing clamps can not be closed unless the
outer air filter is properly installed.
Protection covers
• Make sure all protection covers are in place and in good
condition.
For more information, see the "Machine's safety equipment"
section.
Drain cooling water from gearbox to prevent rust
and/or freeze damage.
• To drain water from gearbox, turn the drain tap
counterclockwise to open and clockwise to close.

Check the water spray over the diamond blade.

• Raise blade guard front and use quick release pin to lock
it in upright position.
– 47
English